Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
  1. Install the 2 retainers and No. 3 cushion to the shock absorber.



    C159325
  1. Temporarily install the shock absorber, cushion and retainer with the nut.



    C159333
  1. Temporarily install the lower side of the shock absorber with the bolt and nut.



2. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



3. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
  1. Tighten the bolt and 2 nuts.

    Torque:
    Upper side:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }
    Lower side:
    90 N*m{ 918 kgf*cm , 66 ft.*lbf }



4. INSTALL REAR WHEEL

Torque:
for Aluminum Wheel:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }
for Steel Wheel:
209 N*m{ 2131 kgf*cm , 154 ft.*lbf }



5. REMOVE SAFETY STANDS