Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. SUPPORT BODY WITH SAFETY STANDS
  1. Jack up and support the body on safety stands.

  1. Lower the axle housing until the leaf spring tension is free, and keep it at this position.



2. REMOVE REAR WHEEL


3. REMOVE REAR SHOCK ABSORBER ASSEMBLY LH


C156228
  1. Support the rear axle housing with a jack using a wooden block to avoid damage.



    C159333
  1. Remove the bolt and nut on the lower side of the shock absorber.



    C159325
  1. While holding the piston rod, remove the nut, retainer, No. 1 cushion and shock absorber.

  1. Remove the 2 retainers and No. 3 cushion from the shock absorber.