Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > DISPOSAL

for Preparation Click here



1. DISPOSE OF SHOCK ABSORBER ASSEMBLY REAR


C159747E01
  1. Fully extend the rear shock absorber rod.

  1. Using a drill, make a hole in the cylinder between A and B shown in the illustration to discharge the gas inside.

    CAUTION:
    Be careful when drilling because shards of metal may fly about. Always use the proper safety equipment.

    NOTICE:
    The gas is colorless, odorless and nonpoisonous.