Home › SUSPENSION & AXLE › SUSPENSION › REAR LEAF SPRING

REAR LEAF SPRING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. SUPPORT BODY WITH SAFETY STANDS
  1. Jack up and support the body on safety stands.

  1. Lower the axle housing until the leaf spring tension is free, and keep it at this position.



2. REMOVE SPARE TIRE


3. REMOVE REAR WHEEL


4. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY


C156229
  1. Remove the 3 bolts and disconnect the cable from the vehicle.



5. DISCONNECT REAR SHOCK ABSORBER ASSEMBLY LH


C244387
  1. Support the rear axle housing with a jack using a wooden block to avoid damage.



    C159333
  1. Remove the bolt and nut, and disconnect the shock absorber lower side from the axle housing.



6. REMOVE REAR SPRING U BOLT


C156233
  1. Remove the 4 nuts, 4 washers and spring seat.

  1. Remove the 2 U bolts.



7. REMOVE REAR SPRING BUMPER SUB-ASSEMBLY
  1. Remove the spring bumper.



8. REMOVE REAR SPRING ASSEMBLY LH


C244388E01
  1. Remove the nut, washer and bolt from the front side.



    C156232E01
  1. Remove the 2 nuts, 2 washers, shackle outer plate, No. 2 spring shackle plate and leaf spring from the rear side.



9. REMOVE TUBE


C156234E01
  1. Using a brass bar and hammer, remove the tube from the frame.



10. REMOVE REAR SPRING SHACKLE BUSH
  1. Remove the 2 bushes from the frame.