Home › STEERING › POWER STEERING › VANE PUMP (for 1GR-FE)

VANE PUMP (for 1GR-FE) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE FAN AND GENERATOR V BELT


    A217571
  1. While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of 6 mm (0.236 in.) into the service hole to fix the belt tensioner in place.

    HINT:
    The pulley bolt for the belt tensioner has a left-hand thread.

  1. Remove the V belt.



4. DRAIN POWER STEERING FLUID


5. DISCONNECT SUCTION HOSE


C158815E01
  1. Disconnect the suction hose.



6. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR


C158739
  1. Disconnect the power steering oil pressure switch connector.



7. DISCONNECT PRESSURE FEED TUBE


    C158817E01
  1. Remove the union bolt and disconnect the pressure feed tube.

  1. Remove the gasket.



8. REMOVE VANE PUMP ASSEMBLY
  1. Disconnect the wire harness clamp.



    F051260E01
  1. Remove the 2 bolts and vane pump.