Home › STEERING › POWER STEERING › VANE PUMP (for 3UR-FE, 3UR-FBE)

VANE PUMP (for 3UR-FE, 3UR-FBE) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE V-BANK COVER SUB-ASSEMBLY


    A165576E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



4. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



5. REMOVE AIR CLEANER ASSEMBLY


    A309637E01
  1. Remove the air cleaner cap.

    1. Disconnect the MAF meter connector.

    2. Using a clip remover, detach the wire harness clamp.

    3. for Type A:
      Unfasten the 4 hook clamps and then remove the air cleaner cap.

    4. for Type B:
      Unfasten the 2 hook clamps and then remove the air cleaner cap.

  1. Remove the air cleaner element.



    A309638E01
  1. Remove the 2 bolts and air cleaner case.



6. REMOVE FAN AND GENERATOR V BELT


    A163770E01
  1. While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of φ 5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.

    HINT:
    The pulley bolt for the belt tensioner has a left-hand thread.

  1. Remove the V belt.



7. DRAIN POWER STEERING FLUID


8. DISCONNECT WIRE HARNESS CLAMP


    C161008
  1. Disconnect the wire harness clamp.



9. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE


    C161009E01
  1. Disconnect the No. 1 oil reservoir to pump hose.



10. DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR


    C161010
  1. Disconnect the power steering oil pressure sensor connector.



11. DISCONNECT PRESSURE FEED TUBE


    C161011E01
  1. Remove the bolt and disconnect the pressure feed tube.

  1. Remove the gasket.



12. REMOVE VANE PUMP ASSEMBLY


    C161012
  1. Remove the 2 bolts and vane pump.