PROPELLER SHAFT ASSEMBLY (for 4WD) > REMOVAL |
| 1. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY |
![]() |
Place matchmarks on the propeller shaft flange and differential flange.
| *a | for Differential Side |
| *b | Matchmark |
Remove the 4 bolts and 4 nuts.
![]() |
w/o Bearing Washer:
Remove the 2 mounting bolts from the frame crossmember.
w/ Bearing Washer:
Remove the 2 mounting bolts and 2 bearing washers from the frame crossmember.
![]() |
Place matchmarks on the propeller shaft flange and transfer flange.
| *a | for Transfer Side |
| *b | Matchmark |
Remove the 4 nuts and propeller shaft.