Home › DRIVE LINE › PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY

FRONT PROPELLER SHAFT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FRONT PROPELLER SHAFT
  1. Completely remove any oil or the like and clean the contact surfaces of the propeller shaft flange, differential flange and transfer flange.



  1. for Front Differential Side:



      C158457E02
    1. Align the matchmarks on the differential and propeller shaft flange.
      Text in Illustration 
      *a
      for Front Differential Side
      *b
      Matchmark

    2. Install the propeller shaft with the 4 washers and 4 nuts.

      Torque:
      80 N*m{ 819 kgf*cm , 59 ft.*lbf }



    C158456E03
  1. for Transfer Side:

    1. Align the matchmarks on the transfer and propeller shaft flange.
      Text in Illustration 
      *a
      for Transfer Side
      *b
      Matchmark

    2. Connect the propeller shaft with the 4 washers and 4 nuts.

      Torque:
      80 N*m{ 819 kgf*cm , 59 ft.*lbf }



2. INSTALL PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY
  1. Install the heat insulator bracket to the crossmember with the 2 bolts.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }



3. INSTALL PROPELLER SHAFT HEAT INSULATOR


C158452
  1. Install the heat insulator to the heat insulator bracket with the 2 bolts.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }