Home › DRIVE LINE › PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY

FRONT PROPELLER SHAFT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT PROPELLER SHAFT JOINT SPIDER BEARING SNAP RING


    C158560E04
  1. Place matchmarks on the flange yoke.
    Text in Illustration 
    *a
    Matchmark



    C158561
  1. Using a brass bar and hammer, slightly tap in the spider bearing outer races.

  1. Using needle-nose pliers, remove the 4 snap rings from the grooves.



2. REMOVE SPIDER BEARING


F015025E09
  1. Using SST, push out the bearing from the flange yoke.

    SST
    09332-25010  

    HINT:
    Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



    F044192E11
  1. Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.
    Text in Illustration 
    *a
    Hammering Point

    NOTICE:
    Do not tap the shaft tube.

    HINT:
    Remove the bearing on the opposite side using the same procedure.



    F015030E08
  1. Install the 2 removed spider bearing outer races to the spider.

  1. Using SST, push the bearing out of the flange yoke.

    SST
    09332-25010  

    HINT:
    Before installing SST, sufficiently raise the part labeled A. If part A is too low, SST may be difficult to install.



    C158562E02
  1. Clamp the outer bearing race in a vise and tap off the flange yoke with a hammer.

  1. Remove the spider.
    Text in Illustration 
    *a
    Hammering Point

    HINT:
    Remove the bearing on the opposite side using the same procedure.