CANISTER > INSTALLATION |
| 1. INSTALL CANISTER PUMP MODULE |
![]() |
Engage the 2 claws to install a new canister pump module to the charcoal canister.
| 2. INSTALL CHARCOAL CANISTER ASSEMBLY |
Install the charcoal canister assembly with the 4 bolts.
Attach the wire harness clamp.
![]() |
Connect the vent line hose.
| *1 | Vent Line Hose |
| *2 | Retainer |
![]() | Push |
Push the hose into the port and push the retainer to lock it.
Connect the air inlet line hose.
Connect the purge line hose.
Connect the canister pump module connector.
Connect the wiring harness clamp bracket with the nut.