Home › ENGINE ยท 1GR-FE › EMISSION CONTROL › CANISTER

CANISTER > REMOVAL

for Preparation Click here



1. REMOVE CHARCOAL CANISTER ASSEMBLY


    A273947
  1. Remove the nut and disconnect the wiring harness clamp bracket.



    A273948E01
  1. Disconnect the canister pump module connector.

  1. Disconnect the purge line hose.
    Text in Illustration 
    *1
    Vent Line Hose
    *2
    Air Inlet Line Hose
    *3
    Charcoal Canister Assembly Side
    *4
    Retainer
    V100136
    Upper
    V100137
    Pinch

  1. Disconnect the air inlet line hose.

    1. Push the hose firmly toward the charcoal canister assembly.

    2. Pinch the hose as shown in the illustration.

    3. Pull out the hose.

      NOTICE:
      1. Do not use any tools in this procedure.
      2. Check for any dirt and foreign matter contamination in the charcoal canister assembly and around the hose. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the charcoal canister assembly and hose.

  1. Disconnect the vent line hose.

    1. Pinch the retainer and raise it.

      NOTICE:
      1. Do not use any tools in this procedure.
      2. Check for any dirt and foreign matter contamination in the valve and around the connector. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the valve and connector.



    A273949
  1. Detach the wire harness clamp.



    A273950
  1. Remove the 4 bolts and charcoal canister assembly.



2. REMOVE CANISTER PUMP MODULE
  1. Before removing the canister pump module, clean the charcoal canister by blowing air into it to ensure that the charcoal canister is free of foreign matter.

    NOTICE:
    1. Make sure to clean the charcoal canister using only air.
    2. Do not use gasoline, thinners or solvents.



    A263349
  1. While disengaging the 2 claws as shown in the illustration, push the canister pump module upwards using a screwdriver to remove it.



  1. Check if the charcoal canister contains foreign matter such as mud or water.



      A263350
    1. Visually check that the inside of the charcoal canister is free of foreign matter.

    2. Hold the charcoal canister upside down to make sure that the charcoal canister is free of foreign matter.
      If the charcoal canister contains foreign matter, replace the charcoal canister.