Home › ENGINE ยท 1UR-FE › IGNITION › IGNITION COIL AND SPARK PLUG

IGNITION COIL AND SPARK PLUG > INSTALLATION

for Preparation Click here


HINT:
Perform "Inspection After Repairs" after replacing the spark plug or ignition coil assembly (Click here).



1. INSTALL SPARK PLUG

HINT:
Perform "Inspection After Repairs" after replacing the spark plug (Click here).

  1. Using a 16 mm plug wrench, install the 8 spark plugs.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }



2. INSTALL IGNITION COIL ASSEMBLY

HINT:
Perform "Inspection After Repairs" after replacing the ignition coil assembly (Click here).

  1. for Bank 1:

    1. Install the 4 ignition coil assemblies with the 4 bolts.

      Torque:
      10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    2. Connect the 4 ignition coil connectors.

    3. Attach the 3 wire harness clamps.

  1. for Bank 2:

    1. Install the 4 ignition coil assemblies with the 4 bolts.

      Torque:
      10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    2. Attach the 2 wire harness clamps and connect the 4 ignition coil connectors.

    3. Connect the water by-pass pipe with the 2 bolts.

      Torque:
      18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    4. Attach the engine wire harness clamp.



3. INSTALL AIR CLEANER ASSEMBLY
  1. Install the air cleaner assembly with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Tighten the hose clamp.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }

  1. Connect the ventilation hose and vacuum hose.

  1. Attach the clamp and connect the mass air flow meter connector.



4. INSTALL V-BANK COVER SUB-ASSEMBLY


    A214821E01
  1. Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover to attach the pins.