Home › ENGINE ยท 3UR-FE › IGNITION › IGNITION COIL AND SPARK PLUG

IGNITION COIL AND SPARK PLUG > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER SUB-ASSEMBLY


    A165576E04
  1. Raise the front of the V-bank cover sub-assembly to detach the 2 pins. Then remove the 2 V-bank cover hooks from the No. 1 V-bank cover bracket, and remove the V-bank cover sub-assembly.
    Text in Illustration 
    *1
    V-bank Cover Grommet
    *2
    Pin
    *3
    No. 1 V-bank Cover Bracket
    *4
    V-bank Cover Hook



2. REMOVE AIR CLEANER HOSE ASSEMBLY


    A187008
  1. Disconnect the vacuum hose from the air cleaner hose assembly.

  1. Slide the clamp and disconnect the ventilation hose from the air cleaner hose assembly.

  1. Loosen the 2 hose clamps.

  1. Remove the air cleaner hose assembly.



3. REMOVE AIR CLEANER ASSEMBLY


    A309637E01
  1. Remove the air cleaner cap.

    1. Disconnect the MAF meter connector.

    2. Using a clip remover, detach the wire harness clamp.

    3. for Type A:
      Unfasten the 4 hook clamps and then remove the air cleaner cap.

    4. for Type B:
      Unfasten the 2 hook clamps and then remove the air cleaner cap.

  1. Remove the air cleaner element.



    A309638E01
  1. Remove the 2 bolts and air cleaner case.



4. REMOVE IGNITION COIL ASSEMBLY


    A151832
  1. Disconnect the 8 ignition coil connectors.

  1. Remove the 8 bolts and 8 ignition coils.



5. REMOVE SPARK PLUG
  1. Using a 16 mm plug wrench, remove the 8 spark plugs.