Home › ENGINE ยท 1UR-FE › IGNITION › IGNITION COIL AND SPARK PLUG

IGNITION COIL AND SPARK PLUG > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER SUB-ASSEMBLY


    A214822E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



2. REMOVE AIR CLEANER ASSEMBLY


    A272399E01
  1. Detach the clamp and disconnect the mass air flow meter connector.
    Text in Illustration 
    *A
    for Type A
    *B
    for Type B

  1. Disconnect the ventilation hose and vacuum hose.

  1. Loosen the hose clamp.

  1. Remove the 2 bolts and air cleaner assembly.



3. REMOVE IGNITION COIL ASSEMBLY


  1. for Bank 1:



      A215594
    1. Detach the 3 wire harness clamps.

    2. Disconnect the 4 ignition coil connectors.



    3. A215593
    4. Remove the 4 bolts and 4 ignition coil assemblies.



  1. for Bank 2:



      A215596
    1. Detach the 2 wire harness clamps.

    2. Disconnect the 4 ignition coil connectors.



    3. A215595
    4. Detach the engine wire harness clamp.



    5. A216323
    6. Remove the 2 bolts and disconnect the water by-pass pipe.



    7. A215597
    8. Remove the 4 bolts and 4 ignition coil assemblies.



4. REMOVE SPARK PLUG
  1. Using a 16 mm plug wrench, remove the 8 spark plugs.