IGNITION COIL AND SPARK PLUG > REMOVAL |
| 1. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Raise the front of the V-bank cover sub-assembly to detach the 2 pins. Then remove the 2 V-bank cover hooks from the No. 1 V-bank cover bracket, and remove the V-bank cover sub-assembly.
| *1 | V-bank Cover Grommet |
| *2 | Pin |
| *3 | No. 1 V-bank Cover Bracket |
| *4 | V-bank Cover Hook |
| 2. REMOVE AIR CLEANER HOSE ASSEMBLY |
![]() |
Disconnect the vacuum hose from the air cleaner hose assembly.
Slide the clamp and disconnect the ventilation hose from the air cleaner hose assembly.
Loosen the 2 hose clamps.
Remove the air cleaner hose assembly.
| 3. REMOVE AIR CLEANER ASSEMBLY |
![]() |
Remove the air cleaner cap.
Disconnect the MAF meter connector.
Using a clip remover, detach the wire harness clamp.
for Type A:
Unfasten the 4 hook clamps and then remove the air cleaner cap.
for Type B:
Unfasten the 2 hook clamps and then remove the air cleaner cap.
Remove the air cleaner element.
![]() |
Remove the 2 bolts and air cleaner case.
| 4. REMOVE IGNITION COIL ASSEMBLY |
![]() |
Disconnect the 8 ignition coil connectors.
Remove the 8 bolts and 8 ignition coils.
| 5. REMOVE SPARK PLUG |
Using a 16 mm plug wrench, remove the 8 spark plugs.