Home › SERVICE SPECIFICATIONS › SERVICE SPECIFICATIONS › POWER STEERING

POWER STEERING > SERVICE DATA



POWER STEERING FLUID 
Fluid level rise (Maximum)
5.0 mm (0.197 in.)
Fluid pressure at idle speed with valve closed
8336 kPa (85.0 kgf/cm2, 1209 psi)
Fluid pressure at idle speed with valve fully open and turn the steering wheel to the full lock position
8336 kPa (85.0 kgf/cm2, 1209 psi)

STEERING WHEEL 
Steering effort at idle speed (Reference)
4.9 N*m (50 kgf*cm, 43 in.*lbf)

VANE PUMP (for 1GR-FE) 
Vane pump shaft and vane pump housing oil clearance (Maximum)
0.07 mm (0.00276 in.)
Vane plate thickness (Standard)
1.405 to 1.411 mm (0.05531 to 0.05555 in.)
Clearance between the vane pump rotor groove and vane pump plate (Maximum)
0.03 mm (0.00118 in.)
Compression spring free length (Minimum)
29.2 mm (1.15 in.)
Vane pump rotating torque
0.3 N*m (3 kgf*cm, 2 in.*lbf) or less

VANE PUMP (for 1UR-FE) 
Vane pump shaft and vane pump housing oil clearance (Maximum)
0.07 mm (0.00276 in.)
Vane plate thickness (Standard)
1.405 to 1.411 mm (0.05531 to 0.05555 in.)
Clearance between the vane pump rotor groove and vane pump plate (Maximum)
0.03 mm (0.00118 in.)
Compression spring free length (Minimum)
29.2 mm (1.15 in.)
Vane pump rotating torque
0.3 N*m (3 kgf*cm, 2 in.*lbf) or less

VANE PUMP (for 3UR-FE, 3UR-FBE) 
Vane pump shaft and vane pump housing oil clearance (Maximum)
0.07 mm (0.00276 in.)
Vane plate thickness (Standard)
1.405 to 1.411 mm (0.05531 to 0.05555 in.)
Clearance between the vane pump rotor groove and vane pump plate (Maximum)
0.03 mm (0.00118 in.)
Compression spring free length (Minimum)
29.2 mm (1.15 in.)
Vane pump rotating torque
0.3 N*m (3 kgf*cm, 2 in.*lbf) or less

POWER STEERING LINK 
Tie rod end sub-assembly stud bolt turning torque
1.0 to 3.9 N*m (10 to 40 kgf*cm, 9 to 34 in.*lbf)
Total preload (Control valve rotating torque)
1.9 to 2.7 N*m (19.4 to 27.5 kgf*cm, 16.8 to 23.9 in.*lbf)