Home › BODY › SLIDING ROOF › SLIDING ROOF HOUSING (for CrewMax)

SLIDING ROOF HOUSING (for CrewMax) > REASSEMBLY

for Preparation Click here



1. INSTALL REAR SLIDING ROOF HOUSING MOUNTING BRACKET LH


    B171166E01
  1. Install the mounting bracket with the 2 bolts.



2. INSTALL REAR SLIDING ROOF HOUSING MOUNTING BRACKET RH

HINT:
Use the same procedures described for the LH side.



3. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


  1. Hold down the window deflector.

    NOTICE:
    B170253
    Make sure that the spring indicated by the arrow in the illustration is securely installed.



    B170254
  1. Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to install it.

    HINT:
    Tape the screwdriver tip before use.



    B171156
  1. Slide each roof wind deflector lifter link in the direction indicated by the arrow in the illustration to install it, then attach the claw.



    B170260
  1. Attach the 4 claws to install the 4 roof wind deflector panel guide clips.



    B170315
  1. Attach the 2 claws to install the drip channel.



4. ADJUST SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


B170257E01
  1. Using a screwdriver, align the matchmarks by sliding the drive cable in the directions indicated by the arrow in the illustration.

    HINT:
    Tape the screwdriver tip before use.



5. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    B171157
  1. Insert the sunshade trim into the sliding roof housing.

  1. Attach the 4 claws to install the sliding roof piece LH and RH.

  1. Install the 2 screws.



6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


B170248
  1. Install the drive gear and room light bracket with the 2 bolts.

    Torque:
    5.4 N*m{ 5.5 kgf*cm , 48 in.*lbf }