Home › BODY › ENGINE HOOD / DOOR › HOOD LOCK CONTROL CABLE ASSEMBLY

HOOD LOCK CONTROL CABLE ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
  1. Pass the hood lock control cable assembly into the engine room.

  1. Pass the rear end of the hood lock control cable assembly through the grommet until the cable stopper is attached to the grommet.

  1. Pass the front end of the hood lock control cable assembly through the upper radiator support.



  1. Attach the hood lock control cable assembly to the clamps as shown in the illustration.


    B354842E01


    Text in Illustration 
    *1
    Hood Lock Control Cable Assembly
    *2
    Clamp
    *3
    Grommet
    -
    -



2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
  1. Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.

  1. Attach the 3 claws to install the hood lock lever sub-assembly.



3. INSTALL HOOD LOCK ASSEMBLY


  1. Apply MP grease to the sliding areas of the hood lock assembly.


    B356561E01


    Text in Illustration 
    *a
    Back Side
    *b
    Front Side

  1. Connect the hood lock control cable assembly.

  1. Install the hood lock assembly.

  1. Install the 2 bolts and hood lock bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Install a new hood lock nut cap.

  1. w/ Engine Hood Courtesy Switch:

    1. Connect the connector.

    2. Attach the clamp.



4. INSTALL RADIATOR GRILLE SUB-ASSEMBLY
  1. Attach the 4 claws and 3 clips to install the radiator grille sub-assembly.

  1. Install the 4 screws and 2 clips.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }