Home › BODY › ENGINE HOOD / DOOR › HOOD LOCK CONTROL CABLE ASSEMBLY

HOOD LOCK CONTROL CABLE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY


    B353342E01
  1. Put protective tape around the radiator grille sub-assembly.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 4 screws and 2 clips.



    B353345
  1. Detach the 4 claws and 3 clips and remove the radiator grille sub-assembly.



2. REMOVE HOOD LOCK ASSEMBLY


B354839
  1. w/ Engine Hood Courtesy Switch:

    1. Disconnect the connector.

    2. Detach the clamp.



    B354830E01
  1. Using a screwdriver, remove the hood lock nut cap.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape



    B354840
  1. Remove the 2 bolts and hood lock bolt.

  1. Remove the hood lock assembly.

  1. Disconnect the hood lock control cable assembly.



3. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B354841
  1. Detach the 3 claws.

  1. Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.



4. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY
  1. Using a screwdriver, detach the hood lock control cable assembly from the clamps as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.



  1. Pull the hood lock control cable assembly from the engine room and remove it.


    B354842E01


    Text in Illustration 
    *1
    Hood Lock Control Cable Assembly
    *2
    Clamp
    *3
    Grommet
    -
    -