Home › BODY ELECTRICAL › DOOR LOCK › REAR DOOR LOCK (for CrewMax)

REAR DOOR LOCK (for CrewMax) > INSPECTION

for Preparation Click here



1. INSPECT REAR DOOR LOCK ASSEMBLY LH


  1. Check the door lock motor.



      B167566E01
    1. Apply battery voltage to the door lock and check operation of the door lock.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4 (L)
      Battery negative (-) → Terminal 1 (UL)
      Lock
      Battery positive (+) → Terminal 1 (UL)
      Battery negative (-) → Terminal 4 (L)
      Unlock

      1. If the result is not as specified, replace the door lock assembly.

  1. Check the door lock position switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      6 (LSSR) - 9 (E)
      Unlock
      Below 1 Ω
      Lock
      10 kΩ or higher

      1. If the result is not as specified, replace the door lock assembly.



2. INSPECT REAR DOOR LOCK ASSEMBLY RH


  1. Check the door lock motor.



      B167567E01
    1. Apply battery voltage to the door lock and check operation of the door lock.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4 (L)
      Battery negative (-) → Terminal 1 (UL)
      Lock
      Battery positive (+) → Terminal 1 (UL)
      Battery negative (-) → Terminal 4 (L)
      Unlock

      1. If the result is not as specified, replace the door lock assembly.

  1. Check the door lock position switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      6 (LSSR) - 9 (E)
      Unlock
      Below 1 Ω
      Lock
      10 kΩ or higher

      1. If the result is not as specified, replace the door lock assembly.