CYLINDER HEAD > REPLACEMENT |
| 1. REPLACE INTAKE VALVE GUIDE BUSH |
Heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
![]() |
Using SST and a hammer, tap out the valve guide bush.
![]() |
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
| Bush Size | Specified Condition |
| STD | 10.285 to 10.306 mm (0.4049 to 0.4057 in.) |
| O/S 0.05 | 10.335 to 10.356 mm (0.4069 to 0.4077 in.) |
Select a new valve guide bush.
| Bush Size | Bush Diameter |
| STD | 10.333 to 10.344 mm (0.4068 to 0.4072 in.) |
| O/S 0.05 | 10.383 to 10.394 mm (0.4088 to 0.4092 in.) |
![]() |
Using SST and a hammer, tap in a new guide bush to the standard protrusion height.
![]() |
Using a sharp 5.5 mm reamer, ream the guide bush to obtain the standard oil clearance between the guide bush and valve stem.
| 2. REPLACE EXHAUST VALVE GUIDE BUSH |
Heat the cylinder head to approximately 80 to 100°C (176 to 212°F).
Place the cylinder head on wooden blocks.
![]() |
Using SST and a hammer, tap out the valve guide bush.
![]() |
Using a caliper gauge, measure the bush bore diameter of the cylinder head.
| Bush Size | Specified Condition |
| STD | 10.285 to 10.306 mm (0.4049 to 0.4057 in.) |
| O/S 0.05 | 10.335 to 10.356 mm (0.4069 to 0.4077 in.) |
Select a new valve guide bush.
| Bush Size | Bush Diameter |
| STD | 10.333 to 10.344 mm (0.4068 to 0.4072 in.) |
| O/S 0.05 | 10.383 to 10.394 mm (0.4088 to 0.4092 in.) |
![]() |
Using SST and a hammer, tap in a new guide bush to the standard protrusion height.
![]() |
Using a sharp 5.5 mm reamer, ream the guide bush to obtain the standard oil clearance between the guide bush and valve stem.
| 3. REPLACE SPARK PLUG TUBE |
![]() |
Remove the spark plug tube.
Apply adhesive to the end of a new spark plug tube.
![]() |
Using a wooden block and hammer, tap in the spark plug tube to the specified protrusion height.
| 4. REPLACE RING PIN |
Remove the ring pins.
Using a plastic-faced hammer, tap in new ring pins to the cylinder head.

| Item | Height | Width | Protrusion |
| Ring pin A | 11 mm (0.433 in.) | 11 mm (0.433 in.) | 5.5 to 6.5 mm (0.217 to 0.256 in.) |
| Ring pin B | 10 mm (0.394 in.) | 11 mm (0.433 in.) | 3.5 to 6.5 mm (0.138 to 0.256 in.) |