Home › ENGINE ยท 1UR-FE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > REASSEMBLY

for Preparation Click here



1. INSTALL STUD BOLT


  1. Using E7 and E8 "TORX" socket wrenches, install the stud bolts.

    Torque:
    for stud bolts A, B, C, D:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



    A214819E01



2. INSTALL NO. 2 STRAIGHT SCREW PLUG


    A164330E02
  1. Using a 14 mm hexagon wrench, install 2 new gaskets and the 2 straight screw plugs.

    Torque:
    85 N*m{ 867 kgf*cm , 63 ft.*lbf }



3. INSTALL NO. 1 STRAIGHT SCREW PLUG


    A145550E03
  1. Using a 10 mm hexagon wrench, install 6 new gaskets and the 6 straight screw plugs.

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }



4. INSTALL VALVE SPRING SEAT
  1. Install the valve spring seats to the cylinder head.



5. INSTALL VALVE STEM OIL SEAL


    A094934E07
  1. Apply a light coat of engine oil to new oil seals.

    NOTICE:
    Pay attention when installing the intake and exhaust oil seals. For example, installing the intake oil seal into the exhaust side or installing the exhaust oil seal into the intake side can cause installation problems later.

    HINT:
    The intake valve oil seals are brown and the exhaust valve oil seals are gray.



    A165065E01
  1. Using SST, push in the oil seals.

    SST
    09201-41020  

    NOTICE:
    Failure to use SST will cause the seal to be damaged or improperly seated.



6. INSTALL INTAKE VALVE


    A094935E17
  1. Apply plenty of engine oil to the tip area of the intake valve shown in the illustration.

  1. Install the valve, compression spring and spring retainer to the cylinder head.

    NOTICE:
    Install the same parts in the same combination to their original locations.



    A164326E01
  1. Using SST and wooden blocks, compress the spring and install the retainer locks.

    SST
    09202-70020   (09202-00010)



    A165066
  1. Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.

    NOTICE:
    Be careful not to damage the retainer.



7. INSTALL EXHAUST VALVE


    A094936E16
  1. Apply plenty of engine oil to the tip area of the exhaust valve shown in the illustration.

  1. Install the valve, compression spring and spring retainer to the cylinder head.

    NOTICE:
    Install the same parts in the same combination to their original locations.



    A164327E01
  1. Using SST and wooden blocks, compress the spring and install the retainer locks.

    SST
    09202-70020   (09202-00010)



    A165067
  1. Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.

    NOTICE:
    Be careful not to damage the retainer.