KNOCK SENSOR > REMOVAL |
| 1. REMOVE INTAKE MANIFOLD |
| 2. REMOVE NO. 2 CYLINDER HEAD COVER |
![]() |
| 3. REMOVE NO. 1 ENGINE COVER |
![]() |
| 4. DISCONNECT NO. 9 WATER BY-PASS HOSE |
![]() |
Slide the clamp and disconnect the No. 9 water by-pass hose from the separator case.
| 5. DISCONNECT NO. 10 WATER BY-PASS HOSE |
![]() |
Slide the clamp and disconnect the No. 10 water by-pass hose from the separator case.
| 6. REMOVE SEPARATOR CASE |
![]() |
Remove the 4 bolts and separator case.
| 7. REMOVE KNOCK SENSOR |
![]() |
Disconnect the 4 knock sensor connectors.
Remove the 4 bolts and 4 knock sensors.