THROTTLE BODY > REMOVAL |
| 1. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant from the radiator.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.

Tighten the radiator drain cock plug by hand.
| 2. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Raise the front of the V-bank cover sub-assembly to detach the 2 pins. Then remove the 2 V-bank cover hooks from the No. 1 V-bank cover bracket, and remove the V-bank cover sub-assembly.
| *1 | V-bank Cover Grommet |
| *2 | Pin |
| *3 | No. 1 V-bank Cover Bracket |
| *4 | V-bank Cover Hook |
| 3. REMOVE AIR CLEANER HOSE ASSEMBLY |
![]() |
Disconnect the vacuum hose from the air cleaner hose assembly.
Slide the clamp and disconnect the ventilation hose from the air cleaner hose assembly.
Loosen the 2 hose clamps.
Remove the air cleaner hose assembly.
| 4. REMOVE THROTTLE BODY ASSEMBLY |
![]() |
Slide the clamp and disconnect the No. 4 water by-pass hose from the No. 3 water by-pass pipe.
Slide the clamp and disconnect the No. 5 water by-pass hose from the water inlet housing.
Disconnect the throttle position sensor and control motor connector.
![]() |
Remove the 4 bolts, throttle with motor body assembly and gasket.
Slide the clamp and remove the No. 4 water by-pass hose from the throttle with motor body assembly.
Slide the clamp and remove the No. 5 water by-pass hose from the throttle with motor body assembly.