Home › BODY › WINDSHIELD / WINDOWGLASS › FRONT PASSENGER SIDE POWER WINDOW SWITCH

FRONT PASSENGER SIDE POWER WINDOW SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (w/o Jam Protection Function)


B166135E09
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 (U) - 3 (B)
    UP
    Below 1 Ω
    1 (D) - 2 (SD)
    4 (U) - 5 (SU)
    OFF
    1 (D) - 2 (SD)
    4 (U) - 5 (SU)
    DOWN
    1 (D) - 3 (B)

    1. If the result is not as specified, replace the power window regulator switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Power Window Regulator Switch Assembly)



2. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (w/ Jam Protection Function)


B231347E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (GND) - 6 (UP)
    AUTO UP
    Below 1 Ω
    1 (GND) - 8 (AUTO)
    4 (LED) - 7 (DOWN)
    1 (GND) - 6 (UP)
    MANUAL UP
    1 (GND) - 7 (DOWN)
    MANUAL DOWN
    4 (LED) - 6 (UP)
    OFF
    4 (LED) - 7 (DOWN)
    1 (GND) - 7 (DOWN)
    AUTO DOWN
    1 (GND) - 8 (AUTO)
    4 (LED) - 6 (UP)

    1. If the result is not as specified, replace the power window regulator switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Power Window Regulator Switch Assembly)