Home › BODY › WINDSHIELD / WINDOWGLASS › REAR POWER WINDOW SWITCH

REAR POWER WINDOW SWITCH > INSPECTION

for Preparation Click here



1. INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY


B166135E10
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 (U) - 3 (B)
    UP
    Below 1 Ω
    1 (D) - 2 (SD)
    4 (U) - 5 (SU)
    OFF
    1 (D) - 2 (SD)
    4 (U) - 5 (SU)
    DOWN
    1 (D) - 3 (B)

    1. If the result is not as specified, replace the rear power window regulator switch assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Rear Power Window Regulator Switch Assembly)