WATER PUMP > ON-VEHICLE INSPECTION |
| 1. INSPECT COOLANT LEAK |
Visually check the water pump assembly.
Check that engine coolant is not dripping from the water pump assembly.
Inspect the area around the water pump assembly.
![]() |
Press the thin paper towel against the coolant (solid matter) adhering to the drain hole or the edge of the drain hole, and check the condition of the thin paper towel.
| 2. INSPECT WATER PUMP ASSEMBLY |
Remove the fan and generator V belt (Click here).
![]() |
Turn the pulley and check that the water pump bearing moves smoothly and quietly.
If necessary, replace the water pump assembly.
Install the fan and generator V belt (Click here).