Home › ENGINE ยท 3UR-FE › ENGINE MECHANICAL › CYLINDER BLOCK

CYLINDER BLOCK > REPLACEMENT

for Preparation Click here



1. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove the straight pin unless it is being replaced.

  1. Remove the straight pins.



  1. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.


    A160713E01

    Standard protrusion:
    Item
    Pin Diameter
    Specified Condition
    Pin A
    10 mm (0.394 in.)
    23 mm (0.906 in.)
    Pin B
    10 mm (0.394 in.)
    11 mm (0.433 in.)
    Pin C
    8 mm (0.315 in.)
    9 mm (0.354 in.)
    Pin D
    4 mm (0.157 in.)
    6 mm (0.236 in.)