Home › ENGINE ยท 1UR-FE › ENGINE MECHANICAL › CYLINDER BLOCK

CYLINDER BLOCK > REPLACEMENT

for Preparation Click here



1. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove the straight pin unless it is being replaced.

  1. Remove the straight pins.



  1. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.


    A214828E01


    Standard Straight Pin:

    Item
    Height
    Width
    Protrusion
    Pin A
    36 mm (1.42 in.)
    10 mm (0.394 in.)
    22 to 24 mm (0.866 to 0.945 in.)
    Pin B
    22 mm (0.866 in.)
    10 mm (0.394 in.)
    10.5 to 11.5 mm (0.413 to 0.453 in.)
    Pin C
    20 mm (0.787 in.)
    8 mm (0.315 in.)
    8.0 to 10.0 mm (0.315 to 0.394 in.)
    Pin D
    12 mm (0.472 in.)
    4 mm (0.157 in.)
    5.0 to 7.0 mm (0.197 to 0.276 in.)