Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensor, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Main Body / Data List.

  5. According to the display on the Techstream, read the "Data List".

    Main Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door Courtesy SW
    Front door courtesy light switch LH signal / ON or OFF
    ON: Front door courtesy light switch LH ON
    OFF: Front door courtesy light switch LH OFF
    -
    P Door Courtesy SW
    Front door courtesy light switch RH signal / ON or OFF
    ON: Front door courtesy light switch RH ON
    OFF: Front door courtesy light switch RH OFF
    -
    RL Door Courtesy SW
    Rear door courtesy light switch LH signal / ON or OFF
    ON: Rear door courtesy light switch LH ON
    OFF: Rear door courtesy light switch LH OFF
    -
    RR Door Courtesy SW
    Rear door courtesy light switch RH signal / ON or OFF
    ON: Rear door courtesy light switch RH ON
    OFF: Rear door courtesy light switch RH OFF
    -
    D-Door Lock Pos SW
    Driver side door unlock detection switch signal / ON or OFF
    ON: Driver side door is unlocked
    OFF: Driver side door is locked
    -
    P-Door Lock Pos SW
    Front passenger side door unlock detection switch signal / ON or OFF
    ON: Front passenger side door is unlocked
    OFF: Front passenger side door is locked
    -
    RL-Door Lock Pos SW
    Rear door unlock detection switch LH signal / ON or OFF
    ON: Rear left door is unlocked
    OFF: Rear left door is locked
    -
    RR-Door Lock Pos SW
    Rear door unlock detection switch RH signal / ON or OFF
    ON: Rear right door is unlocked
    OFF: Rear right door is locked
    -
    Door Lock SW-Lock
    Door control switch lock signal / ON or OFF
    ON: Door control switch is pushed to lock position
    OFF: Door control switch is not pushed
    -
    Door Lock SW-Unlock
    Door control switch lock signal / ON or OFF
    ON: Door control switch is pushed to unlock position
    OFF: Door control switch is not pushed
    -
    Door Key SW-Lock
    Driver door lock/unlock switch lock signal (key-linked lock switch) / ON or OFF
    ON: Driver side door key cylinder is turned to lock position
    OFF: Driver side door key cylinder is not turned
    -
    Door Key SW-Unlock
    Driver door lock/unlock switch unlock signal (key-linked unlock switch) / ON or OFF
    ON: Driver side door key cylinder is turned to unlock position
    OFF: Driver side door key cylinder is not turned
    -
    D Door Key SW-UL
    Driver door lock/unlock switch unlock signal (2 step key-linked unlock switch) / ON or OFF
    ON: Driver side door key cylinder is turned to unlock position
    OFF: Driver side door key cylinder is not turned
    -


PERFORM ACTIVE TEST

HINT:
Using the Techstream to perform Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Main Body / Active Test.

  5. According to the display on the Techstream, perform the "Active Test".

    Main Body: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Door Lock
    Operate door lock motor
    LOCK/UNLOCK
    -
    D-Door Unlock
    Operate driver door lock motor
    ON/OFF
    -