Home › BODY › INSTRUMENT PANEL › INSTRUMENT PANEL SAFETY PAD (for Column Shift Type)

INSTRUMENT PANEL SAFETY PAD (for Column Shift Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE BOX BOTTOM MAT


B355383
  1. Remove the box bottom mat.



2. REMOVE NO. 1 SPEAKER HOLE COVER


    B355374E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover B, detach the 8 clips and remove the No. 1 speaker hole cover.



3. REMOVE FRONT NO. 4 SPEAKER ASSEMBLY (w/ Front Center Speaker)


B355107
  1. Remove the 2 bolts.

  1. Disconnect the connector and remove the front No. 4 speaker assembly.

    NOTICE:
    Do not touch the cone part of the speaker.



4. REMOVE NO. 1 INSTRUMENT PANEL PIN

HINT:
Use the same procedure to remove the No. 1 instrument panel pin on the other side.



    B355376
  1. Remove the screw <E> and No. 1 instrument panel pin.



5. REMOVE DEFROSTER NOZZLE ASSEMBLY


B355377
  1. Disconnect the No. 1 side defroster nozzle duct and No. 2 side defroster nozzle duct from the defroster nozzle assembly.

  1. Remove the 3 screws <E> and defroster nozzle assembly.



6. REMOVE NO. 2 HEATER TO REGISTER DUCT


  1. Remove the 8 screws <E> and No. 2 heater to register duct.


    B355382



7. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT


    B355379
  1. Remove the 2 screws <E> and No. 1 side defroster nozzle duct.



8. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT


    B355380
  1. Remove the 2 screws <E> and No. 2 side defroster nozzle duct.



9. REMOVE INSTRUMENT CLUSTER FINISH PANEL REINFORCEMENT


B355381
  1. Remove the 2 screws <F> and 2 instrument cluster finish panel reinforcements.



10. REMOVE NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)


  1. Detach the 2 clamps.


    B353894E01


    Text in Illustration 
    *a
    Guide
    *b
    Clamp

  1. Remove the 2 screws.

  1. Detach the 2 guides and remove the navigation antenna assembly.



11. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY


    B166453
  1. Disconnect the 2 connectors and remove the instrument panel wire from the front passenger airbag.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



    B166454
  1. Remove the 2 screws.



    B166455E01
  1. Detach the 5 hooks (A).

  1. Detach the 5 hooks (B) and remove the front passenger airbag from the instrument panel.