Home › BODY › INSTRUMENT PANEL › INSTRUMENT PANEL SAFETY PAD (for Column Shift Type)

INSTRUMENT PANEL SAFETY PAD (for Column Shift Type) > REASSEMBLY

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY


    B166456E01
  1. Attach the 5 hooks (A).

  1. Attach the 5 hooks (B) and install the front passenger airbag on the instrument panel.



    B166454
  1. Install the 2 screws.

  1. Connect the 2 connectors and install the instrument panel wire to the front passenger airbag.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



2. INSTALL NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)
  1. Attach the 2 guides to install the navigation antenna assembly.

  1. Install the 2 screws.

  1. Attach the 2 clamps.



3. INSTALL INSTRUMENT CLUSTER FINISH PANEL REINFORCEMENT
  1. Install the 2 instrument cluster finish panel reinforcements with the 2 screws <F>.



4. INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT
  1. Install the No. 1 side defroster nozzle duct with the 2 screws <E>.



5. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT
  1. Install the No. 2 side defroster nozzle duct with the 2 screws <E>.



6. INSTALL NO. 2 HEATER TO REGISTER DUCT
  1. Install the No. 2 heater to register duct with the 8 screws <E>.



7. INSTALL DEFROSTER NOZZLE ASSEMBLY


B355378
  1. Install the defroster nozzle assembly with the 3 screws <E>.

  1. Connect the No. 1 side defroster nozzle duct and No. 2 side defroster nozzle duct to the defroster nozzle assembly.



8. INSTALL NO. 1 INSTRUMENT PANEL PIN

HINT:
Use the same procedure to install the No. 1 instrument panel pin on the other side.

  1. Install the No. 1 instrument panel pin with the screw <E>.



9. INSTALL FRONT NO. 4 SPEAKER ASSEMBLY
  1. Connect the connector.

  1. Temporarily install the front No. 4 speaker assembly by aligning the positioning pins of the front No. 4 speaker assembly with the instrument panel.

  1. Install the front No. 4 speaker assembly with the 2 bolts.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }

    NOTICE:
    1. Do not touch the cone part of the speaker.
    2. When installing the speaker to the instrument panel, be careful so that the wires do not get caught between the parts.



10. INSTALL NO. 1 SPEAKER HOLE COVER


    B355375
  1. Attach the 8 clips to install the No. 1 speaker hole cover.



11. INSTALL BOX BOTTOM MAT
  1. Install the box bottom mat.