COMBINATION METER > INSTALLATION |
| 1. INSTALL COMBINATION METER ASSEMBLY |
Pass the combination meter assembly between the steering wheel assembly and instrument panel.
Connect the connector and attach the wire harness clamp.

| *A | for Column Shift Type | *2 | for Floor Shift Type |
Install the combination meter assembly with the 4 screws.
| 2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
for Column Shift Type:
for Floor Shift Type:
| 3. INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT |
for Column Shift Type:
for Floor Shift Type:
| 4. INSTALL NO. 2 SWITCH HOLE BASE |
Connect each connector.
![]() |
Attach the 4 clips to install the No. 2 switch hole base.
| 5. INSTALL UPPER STEERING COLUMN COVER (for Column Shift Type) |
![]() |
Attach the claw to install the upper steering column cover.
Attach the 4 clips.
| 6. INSTALL LOWER STEERING COLUMN COVER (for Column Shift Type) |
![]() |
Attach the 2 claws to install the lower steering column cover.
Install the 2 screws.
| 7. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
![]() |
Attach the 3 clips and 3 claws to install the No. 1 instrument cluster finish panel garnish.
| 8. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
Connect the hood lock control cable to the hood lock control lever, rotate the hood lock control cable, and then slide and push the hood lock control cable into place.

Attach the 3 hooks to connect the hood lock control lever to the lower instrument panel finish panel sub-assembly LH.
Connect each connector.
![]() |
Attach the 9 clips and 2 claws to install the lower instrument panel finish panel sub-assembly LH.
Install the 2 bolts <A>.
| 9. INSTALL COWL SIDE TRIM BOARD LH |
Attach the 2 clips to install the cowl side trim board LH.
Install the nut.
| 10. INSTALL FRONT DOOR SCUFF PLATE LH |
for Double Cab:
for CrewMax:
for Regular Cab:
| 11. INSTALL LOWER CENTER INSTRUMENT COVER (for Column Shift Type) |
Attach the 2 guides and 2 clips to install the lower center instrument cover.
Install the 2 clips.
| 12. INSTALL INSTRUMENT SIDE PANEL LH |
![]() |
Attach the 4 guides and 3 claws to install the instrument side panel LH.
| 13. INSTALL NO. 1 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY |
![]() |
Attach the 4 clips to install the No. 1 instrument panel register sub-assembly.
| 14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 15. RESTORE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column) |
Restore the Autoaway/Return function setting to the previous condition by changing the customize parameter (Click here).