HEADLIGHT ASSEMBLY > ADJUSTMENT |
| 1. VEHICLE PREPARATION FOR HEADLIGHT AIMING ADJUSTMENT |
Prepare the vehicle:
![]() |
| 2. PREPARATION FOR HEADLIGHT AIMING (Using a Tester) |
Adjust the headlight aim in accordance with the tester instructions.
| 3. PREPARATION FOR HEADLIGHT AIMING (Using a Screen) |
![]() |
Prepare the vehicle:
| *a | 7.62 or 3 m |
Prepare a piece of thick white paper approximately 2 m (6.56 ft.) (height) x 4 m (13.1 ft.) (width) to use as a screen.
Draw a vertical line down the center of the screen (V line).
Set the screen as shown in the illustration.

![]() |
Draw base lines (H, V LH, and V RH lines) on the screen as shown in the illustration.
| *a | V LH Line |
| *b | V Line |
| *c | V RH Line |
| *d | H Line |
| *e | Ground |
H Line (Headlight):
Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the headlight bulb center marks of the low beam headlights.
V LH Line, V RH Line (Center mark position of the left-hand (LH) and right-hand (RH) headlights):
Draw two vertical lines so that they intersect the H line at each center mark (aligned with the center of the low beam headlight bulbs).
| 4. INSPECT HEADLIGHT AIMING |
Cover the headlight or disconnect the connector of the headlight on the opposite side to prevent light from the headlight that is not being inspected from affecting the headlight aiming inspection.
Start the engine.
Turn on the headlight and check if the cutoff line matches the preferred cutoff line in the following illustration.

| 5. ADJUST HEADLIGHT AIMING |
Using a screwdriver, adjust the aim.
Adjust the aim of each headlight so that it is within the specified range by turning each aiming screw with a screwdriver.

| *A | w/o Headlight Leveling | *B | w/ Headlight Leveling |
| *1 | Screwdriver | *2 | Vertical Aiming |