Home › BODY ELECTRICAL › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL REAR COMBINATION LIGHT GUIDE

HINT:
  1. If the rear combination light assembly LH is removed, replace the rear combination light guide.
  2. Use the same procedure for both rear combination light guides.

  1. Attach the 2 claws to install a new rear combination light guide.



2. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH
  1. Put protective tape around the rear combination light assembly LH.

  1. Connect each connector.

  1. Attach the 2 clips to install the rear combination light assembly LH.



  1. Using a T30 "TORX" socket wrench, install the 2 screws.


    E281353E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -