Home › BODY ELECTRICAL › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
  1. Put protective tape around the rear combination light assembly LH.

  1. Using a T30 "TORX" socket wrench, remove the 2 screws.

  1. Detach the 2 clips.



  1. Disconnect each connector and remove the rear combination light assembly LH.


    E281352E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



2. REMOVE REAR COMBINATION LIGHT GUIDE


E285936E01

HINT:
  1. If the rear combination light assembly LH is removed, replace the rear combination light guide.
  2. Use the same procedure for both rear combination light guides.

  1. Using a screwdriver, detach the 2 claws and remove the rear combination light guide.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Tape