Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE SPIRAL CABLE SUB-ASSEMBLY
(Click here)


4. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    E146421
  1. Disconnect the 2 connectors.

  1. Detach the claw and remove the wiper switch.

    NOTICE:
    Do not push the claw with excessive force as it may brake.



5. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY
  1. Disconnect the connector.



  1. While loosening the band clamp as shown in the illustration, detach the claw.


    E281387E01


    Text in Illustration 
    *A
    for Manual Tilt, for Manual Tilt and Manual Telescopic Steering Column
    *B
    for Power Tilt and Power Telescopic Steering Column



  1. Remove the headlight dimmer switch assembly.

    NOTICE:
    If the claw is pressed forcefully, it will break.



    E281388E01


    Text in Illustration 
    *A
    for Manual Tilt, for Manual Tilt and Manual Telescopic Steering Column
    *B
    for Power Tilt and Power Telescopic Steering Column