Home › BODY ELECTRICAL › LIGHTING › STOP LIGHT SWITCH

STOP LIGHT SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
  1. Attach the 2 claws to install a new stop light switch mounting adjuster.



2. INSTALL STOP LIGHT SWITCH ASSEMBLY


E145371E02
  1. Install the stop light switch assembly to the stop light switch mounting adjuster until the switch body slightly touches the brake pedal.

    NOTICE:
    Do not depress the brake pedal.

    Text in Illustration 
    *1
    Brake Pedal
    *2
    Stop Light Switch Mounting Adjuster
    *3
    Stop Light Switch Assembly



    E146102E02
  1. Rotate the stop light switch assembly clockwise so that the clearance is between 1.5 and 2.5 mm (0.0590 and 0.0984 in.) as shown in the illustration.

    NOTICE:
    Do not depress the brake pedal.

    Text in Illustration 
    *1
    Shaft
    *2
    Stop Light Switch Assembly
    *a
    1.5 to 2.5 mm

  1. Check the stop light switch assembly clearance.

    Stop light switch assembly clearance:
    1.5 to 2.5 mm (0.0590 to 0.0984 in.)

  1. Connect the connector to the stop light switch assembly.

  1. Install the stop light switch cover.