Home › BODY ELECTRICAL › LIGHTING › STOP LIGHT SWITCH

STOP LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STOP LIGHT SWITCH ASSEMBLY


E142949E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed
    10 kΩ or higher
    Not pushed
    Below 1 Ω
    3 - 4
    Pushed
    Below 1 Ω
    Not pushed
    10 kΩ or higher

    If the result is not as specified, replace the stop light switch assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Stop Light Switch Assembly)
    *b
    Pushed
    *c
    Not pushed