Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > Front Passenger Side Door Lock Motor Circuit

for Preparation Click here


DESCRIPTION

The main body ECU controls the front door lock motor RH to lock/unlock the front door RH. This ECU applies current from terminal ACT+ to terminal ACT- to operate the motor to lock the door. It reverses the direction of the current flow to operate the motor to unlock the door.

WIRING DIAGRAM


E144950E05


INSPECTION PROCEDURE

1.INSPECT FRONT DOOR LOCK MOTOR ASSEMBLY RH
E147083E01
  1. Remove the front door lock motor RH.

    1. for Double Cab: (Click here)
    2. for Regular Cab: (Click here)
    3. for CrewMax: (Click here)

  1. Apply battery voltage and check operation of the door lock motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4 (L)
    Battery negative (-) → Terminal 1 (UL)
    Lock
    Battery positive (+) → Terminal 1 (UL)
    Battery negative (-) → Terminal 4 (L)
    Unlock

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Double Cab)
    B
    NG (for Regular Cab)
    C
    NG (for CrewMax)
    D



B
REPLACE FRONT DOOR LOCK MOTOR ASSEMBLY RH (Click here)

C
REPLACE FRONT DOOR LOCK MOTOR ASSEMBLY RH (Click here)

D
REPLACE FRONT DOOR LOCK MOTOR ASSEMBLY RH (Click here)
A


2.CHECK HARNESS AND CONNECTOR (FRONT DOOR LOCK MOTOR RH - MAIN BODY ECU)

E146616E03

  1. Disconnect the M4 door lock connector.

  1. Disconnect the DD ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    M4-4 (L) - DD-3 (ACT+)
    Always
    Below 1 Ω
    M4-1 (UL) - DD-2 (ACT-)
    DD-3 (ACT+) - Body ground
    Always
    10 kΩ or higher
    DD-2 (ACT-) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU