CAN COMMUNICATION SYSTEM > PRECAUTION |
| 1. STEERING SYSTEM HANDLING PRECAUTIONS |
Care must be taken when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazards when driving.
| 2.SRS AIRBAG SYSTEM HANDLING PRECAUTIONS |
This vehicle is equipped with an SRS (Supplemental Restraint System), which includes components such as the driver airbag and front passenger side airbag. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may lead to a serious accident. Before servicing (including installation/removal, inspection and replacement of parts), be sure to read the precautionary notice for the Supplemental Restraint System (Click here).
| 3. BUS LINE REPAIR |
![]() |
After repairing the bus line with solder, wrap the repaired part with vinyl tape (Click here).
![]() |
Do not use by-pass wiring between the connectors.
| *1 | By-pass Wire |
| 4.CONNECTOR HANDLING |
![]() |
When inserting probes into a connector, insert them from the rear of the connector.
| *1 | Tester Probe |
![]() |
Use a repair wire to check the connector if it is impossible to check resistance from the rear of the connector.
| *1 | Repair Wire |
| 5.PRECAUTIONS WHEN REPLACING A GATEWAY FUNCTION EQUIPPED ECU (SUB BUS MONITOR ECU) WITH A USED ONE FROM ANOTHER VEHICLE |
When a gateway function equipped ECU (network gateway ECU) that was previously installed on another vehicle is used as a replacement part, it is necessary to initialize the connection information stored in the ECU.
Initialize the connection information of a gateway function equipped ECU (sub bus monitor ECU)
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body or Gateway / Utility.
Select Initialization from Utility to initialize the ECU.