Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

DTC    U0208    Lost Communication with "Seat Control Module A"

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
U0208
There is no communication from the front power seat control ECU with switch LH.
  1. Power source or inside front power seat control ECU and switch LH
  2. Front power seat control ECU and switch LH CAN branch wire or connector
  3. Front power seat control ECU and switch LH
  1. For vehicles with a seat memory.

WIRING DIAGRAM


C251476E18


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Operating the ignition switch, any other switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.

1.PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


NEXT


2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


3.CHECK FOR OPEN IN CAN BUS WIRE (FRONT POWER SEAT CONTROL ECU AND SWITCH LH CAN BRANCH WIRE)


    C219233E04
  1. Disconnect the Z10 front power seat control ECU and switch LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    Z10-8 (CANP) - Z10-7 (CANN)
    Ignition switch off
    54 to 69 Ω

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to Front Power Seat Control ECU and Switch LH)



NG
REPAIR OR REPLACE FRONT POWER SEAT CONTROL ECU AND SWITCH LH CAN BRANCH WIRE OR CONNECTOR (CANP, CANN)
OK


4.CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT CONTROL ECU AND SWITCH LH - BATTERY AND BODY GROUND)


    C219234E07
  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect the Z9 front power seat control ECU and switch LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Z9-2 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Z9-7 (+B1) - Body ground
    Always
    11 to 14 V
    Z10-12 (SYSB) - Body ground
    Always
    11 to 14 V

Text in Illustration 
*a
Rear view of wire harness connector
(to Front Power Seat Control ECU and Switch LH)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE FRONT POWER SEAT CONTROL ECU AND SWITCH LH (Click here)