AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > IG Power Source Circuit |

| 1.INSPECT FUSE (ECU-IG1 No.4) |
Remove the ECU-IG1 No.4 fuse from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ECU-IG1 No.4 fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY AND BODY GROUND) |
![]() |
Disconnect the J19 air conditioning amplifier connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J19-14 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
| J19-1 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | ||
| ||