AIR CONDITIONING UNIT > DISASSEMBLY |
| 1. REMOVE LOWER DEFROSTER NOZZLE ASSEMBLY |
![]() |
Detach the 4 claws and remove the lower defroster nozzle assembly.
| 2. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY |
![]() |
Detach the 4 claws and remove the No. 1 air duct sub-assembly.
| 3. REMOVE AIR FILTER COVER PLATE |
![]() |
Detach the 2 claws and remove the air filter cover plate.
| 4. REMOVE CLEAN AIR FILTER |
![]() |
Remove the clean air filter.
| 5. REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY |
![]() |
Remove the screw and No. 3 air duct sub-assembly.
| 6. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY |
![]() |
for Manual Air Conditioning System:
Disconnect the 2 connectors.
for Automatic Air Conditioning System:
Disconnect the 3 connectors.
Remove the 2 screws and air conditioning amplifier assembly.
| *A | for Manual Air Conditioning System |
| *B | for Automatic Air Conditioning System |
| 7. REMOVE BLOWER WITH FAN MOTOR SUB-ASSEMBLY |
![]() |
Remove the 3 screws and blower with fan motor sub-assembly.
| 8. REMOVE AIR DUCT |
![]() |
Remove the 2 screws and air duct.
| 9. REMOVE NO. 1 DAMPER SERVO SUB-ASSEMBLY |
![]() |
Disconnect the 2 connectors.
Remove the 4 screws and No. 1 damper servo sub-assembly.
| 10. REMOVE DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System) |
![]() |
Disconnect the connector.
Remove the 3 screws and damper servo sub-assembly.
| 11. REMOVE BLOWER UPPER CASE SUB-ASSEMBLY |
![]() |
Remove the 3 screws.
Detach the 2 claws and remove the blower upper case sub-assembly.
| 12. REMOVE BLOWER DAMPER SERVO SUB-ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 3 screws and blower damper servo sub-assembly.
| 13. REMOVE COOLING UNIT DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System) |
![]() |
Disconnect the connector.
Remove the 3 screws and cooling unit damper servo sub-assembly.
| 14. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY |
![]() |
Remove the 3 screws and plate.
![]() |
Detach the 3 claws and remove the heater clamp.
Remove the heater radiator unit sub-assembly.
| 15. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
![]() |
Remove the No. 1 cooling unit packing and No. 2 cooling unit packing.
![]() |
Remove the 6 screws and detach the 3 claws.
Remove the blower case (back side).
![]() |
Remove the No. 1 cooler evaporator sub-assembly from the blower case (front side).
| 16. REMOVE NO. 1 COOLER THERMISTOR |
![]() |
Remove the No. 1 cooler thermistor.
| 17. REMOVE COOLER EXPANSION VALVE |
![]() |
Using a 4 mm hexagon wrench, remove the 2 bolts.
Remove the tube and accessory and 2 O-rings.
Remove the cooler expansion valve and 2 O-rings from the No. 1 cooler evaporator sub-assembly.