Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING AMPLIFIER

AIR CONDITIONING AMPLIFIER > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE RH
for Regular Cab:
for Double Cab:
for CrewMax:


4. REMOVE COWL SIDE TRIM BOARD RH
for Regular Cab:
for Double Cab:
for CrewMax:


5. REMOVE INSTRUMENT SIDE PANEL RH
for Column Shift Type:
for Floor Shift Type:


6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
for Column Shift Type:
for Floor Shift Type:


7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
for Column Shift Type:
for Floor Shift Type:


8. REMOVE LOWER INSTRUMENT PANEL
for Column Shift Type:
for Floor Shift Type:


9. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
for Column Shift Type:
for Floor Shift Type:


10. REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY


    E281045
  1. Remove the screw and No. 3 air duct sub-assembly.



11. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY


    E281046E01
  1. for Manual Air Conditioning System:
    Disconnect the 2 connectors.

  1. for Automatic Air Conditioning System:
    Disconnect the 3 connectors.

  1. Remove the 2 screws and air conditioning amplifier assembly.
    Text in Illustration 
    *A
    for Manual Air Conditioning System
    *B
    for Automatic Air Conditioning System