Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › NETWORK GATEWAY ECU

NETWORK GATEWAY ECU > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
  1. When disassembling the network gateway ECU, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.
  2. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE RH
for Regular Cab:
for Double Cab:
for CrewMax:


4. REMOVE COWL SIDE TRIM BOARD RH
for Regular Cab:
for Double Cab:
for CrewMax:


5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
for Column Shift Type:
for Floor Shift Type:


6. REMOVE LOWER INSTRUMENT PANEL
for Column Shift Type:
for Floor Shift Type:


7. REMOVE INSTRUMENT SIDE PANEL RH
for Column Shift Type:
for Floor Shift Type:


8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
for Column Shift Type:
for Floor Shift Type:


9. REMOVE NETWORK GATEWAY ECU


    E281048
  1. Disconnect the connector.

  1. Remove the nut and network gateway ECU.