Home › SECURITIES › THEFT DETERRENT › THEFT WARNING ECU

THEFT WARNING ECU > INSTALLATION


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL GLASS BREAKAGE SENSOR ECU
  1. Install the glass breakage sensor ECU with the nut.

    Torque:
    7.6 N*m{ 77 kgf*cm , 67 in.*lbf }

  1. Install the junction block with the 2 nuts.

  1. Connect each connector.



2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B225998
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Attach the 2 claws to install the DLC3.

  1. Install the 4 bolts to install the instrument panel airbag.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. for Column Shift Type:

  1. for Floor Shift Type:



4. INSTALL INSTRUMENT SIDE PANEL LH
  1. for Column Shift Type:

  1. for Floor Shift Type:



5. INSTALL COWL SIDE TRIM BOARD LH
  1. for Regular Cab:

  1. for Double Cab:

  1. for CrewMax:



6. INSTALL FRONT DOOR SCUFF PLATE LH
  1. for Regular Cab:

  1. for Double Cab:

  1. for CrewMax:



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



8. CHECK SRS WARNING LIGHT
(Click here)