Home › SECURITIES › THEFT DETERRENT › THEFT WARNING ECU

THEFT WARNING ECU > REMOVAL



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT DOOR SCUFF PLATE LH
  1. for Regular Cab:

  1. for Double Cab:

  1. for CrewMax:



4. REMOVE COWL SIDE TRIM BOARD LH
  1. for Regular Cab:

  1. for Double Cab:

  1. for CrewMax:



5. REMOVE INSTRUMENT SIDE PANEL LH
  1. for Column Shift Type:

  1. for Floor Shift Type:



6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. for Column Shift Type:

  1. for Floor Shift Type:



7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B225997
  1. Remove the 4 bolts and remove the instrument panel airbag.

  1. Detach the 2 claws and disconnect the DLC3.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



8. REMOVE GLASS BREAKAGE SENSOR ECU


B355130
  1. Disconnect each connector.

  1. Remove the 2 nuts and junction block.



    B167202
  1. Remove the nut and glass breakage sensor ECU.