SEAT HEATER SWITCH > REMOVAL |
| 1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Twist the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.
| 2. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY |
Move the shift lever to N.
![]() |
Apply protective tape as shown in the illustration.
| *1 | Protective Tape |
Using a moulding remover B, detach the 6 clips and remove the upper rear console panel sub-assembly.
| 3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Detach the 12 clips and remove the upper console panel sub-assembly.
| 4. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY |
![]() |
Using a moulding remover B, detach the 7 clips and remove the rear console end panel sub-assembly.
w/ Power Outlet Socket:
Detach the 2 wire harness clamps and disconnect the connector.
| 5. REMOVE CONSOLE BOX CARPET |
![]() |
Remove the console box carpet.
| 6. REMOVE REAR CONSOLE BOX ASSEMBLY |
![]() |
Disconnect the 2 connectors.
Remove the 2 screws <E> and 4 bolts <B> and rear console box assembly.
| 7. REMOVE FRONT CONSOLE BOX |
![]() |
Remove the 2 clips and detach the connector.
Remove the 5 screws <E> and front console box.
| 8. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (SEAT HEATER SWITCH) |
![]() |
Put protective tape around the air conditioning control assembly (seat heater switch).
| *1 | Protective Tape |
Using moulding remover B, detach the 8 clips, 2 claws and guide.
Disconnect each connector to remove the air conditioning control assembly (seat heater switch) together with the center lower instrument panel finish panel.
![]() |
Detach the 3 clips and disconnect the air conditioning control assembly (seat heater switch) from the center lower instrument panel finish panel.
| *1 | Air Conditioning Control Assembly (Seat Heater Switch) |
| *2 | Center Lower Instrument Panel Finish Panel |