Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING RESET SWITCH

TIRE PRESSURE WARNING RESET SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab)


B165843
  1. Detach the 6 claws and 3 clips, and remove the front door scuff plate LH.



2. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab, for CrewMax)


B165841
  1. Detach the 6 claws and 3 clips, and remove the front door scuff plate LH.



3. REMOVE COWL SIDE TRIM BOARD LH


B165704
  1. Remove the nut.

  1. Detach the 2 clips and remove the cowl side trim board LH.



4. REMOVE INSTRUMENT SIDE PANEL LH


    B355333
  1. Using a moulding remover B, detach the 3 claws, 4 guides and remove the instrument side panel LH.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
  1. Operate the tilt lever to fully extend and raise the steering column.



    B355337E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 2 bolts <A>.

  1. Detach the 9 clips, 2 claws and remove the lower instrument panel finish panel sub-assembly LH.

  1. Disconnect each connector.



    B355336
  1. Detach the 3 hooks and disconnect the hood lock control lever from the lower instrument panel finish panel sub-assembly LH.



  1. Pull and slide the hood lock control cable, rotate the hood lock control cable, and then disconnect the hood lock control cable from the hood lock control lever.


    B355339



6. REMOVE TIRE PRESSURE WARNING RESET SWITCH


    C295012
  1. Disconnect the switch connector.

  1. Detach the 2 claws and remove the tire pressure warning reset switch.